The fifth lesson of 5 lessons on system OrCAD
Sold 2
Refunds 0
Good feedbacks 0
Bad feedbacks 0
The fifth lesson of 5 lessons
Course content (for lessons):
1. Creation of the concept in the Capture.
2. Preparation * .mnl file.
3. Binding of circuit elements with footprint-th PCB.
4. Enter the border of the PCB and the automatic placement of elements.
5. Automatic PCB layout.
The course consists of documents prepared in a text editor, word and video files with the extension * .avi, showing the stages of the design. At the end of each lesson, you are invited to perform a control task.
Course content (for lessons):
1. Creation of the concept in the Capture.
2. Preparation * .mnl file.
3. Binding of circuit elements with footprint-th PCB.
4. Enter the border of the PCB and the automatic placement of elements.
5. Automatic PCB layout.
The course consists of documents prepared in a text editor, word and video files with the extension * .avi, showing the stages of the design. At the end of each lesson, you are invited to perform a control task.